Class 12 Chemistry - Chapter The Solid State NCERT Solutions | Why do solids have a definite volume?

If NaCl is doped with 10^-3mol % of SrCl₂, what is the concentration of cation vacancies?

A cubic solid is made of two elements P and Q. Atoms of Q are at the corners of the cube and P at the body-centre. What is the formula of the compound? What are the coordination numbers of P and Q?

An element with molar mass 2.7 x 10^-2kg mol^-1 forms a cubic unit cell with edge length 405 pm. If its density is 2.7 x 10³ kg m^-3, what is the nature of the cubic unit cell?

Copper crystallises into a fcc lattice with edge length 3.61 x 10^-8cm. Show that the calculated density is in agreement with its measured value of 8.92 g cm^-3.

A compound is formed by two elements M and N. The element N forms ccp and atoms of M occupy 1/3^rd of tetrahedral voids. What is the formula of the compound?

Aluminium crystallises in a cubic close-packed structure. Its metallic radius is 125 pm.

(i) What is the length of the side of the unit cell?

(ii) How many unit cells are there in 1.00 cm3of aluminium?

Analysis shows that nickel oxide has the formula Ni_0.98 O_1.00. What fractions of nickel exist as Ni²⁺and Ni³⁺ions?

Distinguish between

(i)Hexagonal and monoclinic unit cells

(ii) Face-centred and end-centred unit cells.

Solid A is a very hard electrical insulator in solid as well as in molten state and melts at extremely high temperature. What type of solid is it?

Ionic solids, which have anionic vacancies due to metal excess defect, develop colour. Explain with the help of a suitable example.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Consider the reaction:

Cr₂ O₇^2- + 14H⁺ + 6e^- → Cr³⁺ + 8H₂O 

What is the quantity of electricity in coulombs needed to reduce 1 mol of Cr₂ O₇^2-?

The molar conductivity of 0.025 mol L-1 methanoic acid is

46.1 S cm2 mol^-1.

Calculate its degree of dissociation and dissociation constant. Given λ⁰(H+)

= 349.6 S cm² mol^-1 and  λ⁰(HCOO^-) = 54.6 S cm² mol

Why is use of aspartame limited to cold foods and drinks?

Why do gases always tend to be less soluble in liquids as the temperature is raised?

What problem arises in using alitame as artificial sweetener?

Write down the number of 3d electrons in each of the following ions:

Ti²⁺, V²⁺, Cr³⁺, Mn²⁺, Fe²⁺, Fe³⁺, CO²⁺, Ni²⁺ and Cu²⁺.

Indicate how would you expect the five 3d orbitals to be occupied for these hydrated ions (octahedral).

Predict the products formed when cyclohexanecarbaldehyde reacts with following reagents.

(i) PhMgBr and then H₃O⁺

(ii)Tollens' reagent

(iii) Semicarbazide and weak acid

(iv)Excess ethanol and acid

(v) Zinc amalgam and dilute hydrochloric acid

What is the role of cryolite in the metallurgy of aluminium?

Predict the number of unpaired electrons in the square planar [Pt(CN)₄]^2- ion.

[NiCl₄]^2- is paramagnetic while [Ni(CO)₄] is diamagnetic though both are tetrahedral. Why?