Class 12 Chemistry - Chapter Electrochemistry NCERT Solutions | In the button cells widely used in watch

If a current of 0.5 ampere flows through a metallic wire for 2 hours, then how many electrons would flow through the wire?

Calculate the emf of the cell in which the following reaction takes place:

Ni_(s) + 2Ag⁺ (0.002 M) → Ni²⁺ (0.160 M) + 2Ag_(s)

Given that E^ø_cell = 1.05 V

Depict the galvanic cell in which the reaction Zn(s) + 2Ag⁺(aq) → Zn²⁺(aq) + 2Ag(s) takes place.

Further show:

(i) Which of the electrode is negatively charged?

(ii) The carriers of the current in the cell.

(iii) Individual reaction at each electrode.

Calculate the standard cell potentials of galvanic cells in which the following reactions take place:

(i) 2Cr(s) + 3Cd²⁺(aq) → 2Cr³⁺(aq) + 3Cd

(ii) Fe²⁺(aq) + Ag+(aq) → Fe³⁺(aq) + Ag(s)

Calculate the ΔrG^ø¸ and equilibrium constant of the reactions.

Write the Nernst equation and emf of the following cells at 298 K:

(i) Mg(s) | Mg²⁺(0.001M) || Cu²⁺(0.0001 M) | Cu(s)

(ii) Fe(s) | Fe²⁺(0.001M) || H⁺(1M)|H₂(g)(1bar) | Pt(s)

(iii) Sn(s) | Sn²⁺(0.050 M) || H⁺(0.020 M) | H₂(g) (1 bar) | Pt(s)

(iv) Pt(s) | Br₂(l) | Br^-(0.010 M) || H⁺(0.030 M) | H₂(g) (1 bar) | Pt(s).

Define conductivity and molar conductivity for the solution of an electrolyte. Discuss their variation with concentration.

How would you determine the standard electrode potential of the system Mg²⁺ | Mg?

Predict the products of electrolysis in each of the following:

(i) An aqueous solution of AgNO₃ with silver electrodes.

(ii) An aqueous solution of AgNO₃with platinum electrodes.

(iii) A dilute solution of H₂SO₄with platinum electrodes.

(iv) An aqueous solution of CuCl₂ with platinum electrodes.

A solution of Ni(NO₃)₂ is electrolysed between platinum electrodes using a current of 5 amperes for 20 minutes. What mass of Ni is deposited at the cathode?

The resistance of a conductivity cell containing 0.001M KCl solution at 298 K is 1500 Ω. What is the cell constant if conductivity of 0.001M KCl solution at 298 K is 0.146 x 10^-3 S cm^-1.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Name the parameters that characterize a unit cell.

Actinoid contraction is greater from element to element than lanthanoid contraction. Why?

Complete the following reactions:

(i)

(ii)

(iii)

(iv)

(v)

(vi)

(vii)

The decomposition of NH₃on platinum surface is zero order reaction. What are the rates of production of N₂and H₂if k = 2.5 x 10^-4mol^-1L s^-1?

How many mL of 0.1 M HCl are required to react completely with 1 g mixture of Na₂CO₃ and NaHCO₃ containing equimolar amounts of both?

Give reason for the higher boiling point of ethanol in comparison to methoxymethane.

Write the equation of the reaction of hydrogen iodide with:

(i) 1-propoxypropane

(ii) Methoxybenzene and

(iii) Benzyl ethyl ether

Mention the factors that affect the rate of a chemical reaction.

How are colloids classified on the basis of

(i) Physical states of components

(ii) Nature of dispersion medium and

(iii) Interaction between dispersed phase and dispersion medium?