Class 12 Chemistry - Chapter Coordination Compounds NCERT Solutions | What is crystal field splitting energy?

[NiCl₄]^2- is paramagnetic while [Ni(CO)₄] is diamagnetic though both are tetrahedral. Why?

Explain on the basis of valence bond theory that [Ni(CN)₄]^2- ion with square planar structure is diamagnetic and the [Ni(CN)₄]^2- ion with tetrahedral geometry is paramagnetic.

Draw figure to show the splitting of d orbitals in an octahedral crystal field.

Write down the IUPAC name for each of the following complexes and indicate the oxidation state, electronic configuration and coordination number. Also give stereochemistry and magnetic moment of the complex:

(i) K[Cr(H₂O)₂(C₂O₄)₂].3H₂O

(ii) [Co(NH₃)₅Cl]Cl₂

(iii) CrCl₃(py)₃

(iv) Cs[FeCl₄]

(v) K₄[Mn(CN)₆]

[Cr(NH₃)₆]³⁺ is paramagnetic while [Ni(CN)₄]^2- is diamagnetic.  Explain why?

The oxidation number of cobalt in K[Co(CO)₄] is

(i) +1

(ii) +3

(iii) -1

(iv) -3

Discuss the nature of bonding in metal carbonyls.

Discuss the nature of bonding in the following coordination entities on the basis of valence bond theory:

(i) [Fe(CN)₆]^4-

(ii) [FeF₆]^3-

(iii) [Co(C₂O₄)3]^3-

(iv) [CoF₆]^3-

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

Predict the number of unpaired electrons in the square planar [Pt(CN)₄]^2- ion.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Write reactions of the final alkylation product of aniline with excess of methyl iodide in the presence of sodium carbonate solution.

Write chemical reactions taking place in the extraction of zinc from zinc blende.

100 g of liquid A (molar mass 140 g mol^-1) was dissolved in 1000 g of liquid B (molar mass 180 g mol^-1). The vapour pressure of pure liquid B was found to be 500 torr. Calculate the vapour pressure of pure liquid A and its vapour pressure in the solution if the total vapour pressure of the solution is 475 Torr.

Write structures of the compounds whose IUPAC names are as follows:

(i) 2-Methylbutan-2-ol

(ii) 1-Phenylpropan-2-ol

(iii) 3,5-Dimethylhexane -1, 3, 5-triol

(iv) 2,3 - Diethylphenol

(v) 1 - Ethoxypropane

(vi) 2-Ethoxy-3-methylpentane

(vii) Cyclohexylmethanol

(viii) 3-Cyclohexylpentan-3-ol

(ix) Cyclopent-3-en-1-ol

(x) 3-Chloromethylpentan-1-ol.

Why is sulphuric acid not used during the reaction of alcohols with KI?

Is it true that under certain conditions, Mg can reduce SiO₂ and Si can reduce MgO? What are those conditions?

Suppose a solid solution is formed between two substances, one whose particles are very large and the other whose particles are very small. What kind of solid solution is this likely to be?

Why is it necessary to remove CO when ammonia is obtained by Haber's process?

What type of defect can arise when a solid is heated? Which physical property is affected by it and in what way?

The chemistry of the actinoid elements is not so smooth as that of the Lanthanoids. Justify this statement by giving some examples from the oxidation state of these elements.