Class 12 Chemistry - Chapter Chemistry in Everyday Life NCERT Solutions | How are synthetic detergents better than

Why do soaps not work in hard water?

Explain the following terms with suitable examples

(i) cationic detergents

(ii) anionic detergents and

(iii) non-ionic detergents.

What are food preservatives ?

Sleeping pills are recommended by doctors to the patients suffering from sleeplessness but it is not advisable to take its doses without consultation with the doctor, Why?

How do antiseptics differ from disinfectants ? Give one example of each. 

Why is use of aspartame limited to cold foods and drinks?

With reference to which classification has the statement, ranitidine is an antacid been given?

What are the main constituents of dettol?

Write the chemical equation for preparing sodium soap from glyceryl oleate and glyceryl palmitate. Structural formulae of these compounds are given below.

(i) (C₁₅H₃₁COO)₃ C₃H₅ - Glyceryl palmitate

(ii)(C₁₇H₃₃COO)₃ C₃H₅ - Glyceryl oleate

What are artificial sweetening agents? Give two examples.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Name the following compounds according to IUPAC system.

(i)

(ii)

(iii)

(iv)

(v)

Arrange the following in the order of property indicated for each set:

(i) F₂, Cl₂, Br₂, I₂- increasing bond dissociation enthalpy.

(ii) HF, HCl, HBr, HI - increasing acid strength.

(iii) NH₃, PH₃, AsH₃, SbH₃, BiH₃- increasing base strength.

Define the following terms:

(i) Mole fraction    (ii) Molality    (iii) Molarity   (iv) Mass percentage.

Vapour pressure of pure water at 298 K is 23.8 mm Hg. 50 g of urea (NH₂CONH₂) is dissolved in 850 g of water. Calculate the vapour pressure of water for this solution and its relative lowering.

Aluminium crystallises in a cubic close-packed structure. Its metallic radius is 125 pm.

(i) What is the length of the side of the unit cell?

(ii) How many unit cells are there in 1.00 cm3of aluminium?

The following data were obtained during the first order thermal decomposition of SO₂Cl₂at a constant volume.

SO₂Cl₂₍g)  →  SO₂₍g) + Cl₂(g)

Calculate the rate of the reaction when total pressure is 0.65 atm.

Write the name and structure of one of the common initiators used in free radical addition polymerisation.

Copper can be extracted by hydrometallurgy but not zinc. Explain.

Write the monomers used for getting the following polymers. (i) Polyvinyl chloride (ii) Teflon (iii) Bakelite

Write the mechanism of hydration of ethene to yield ethanol.