How do antiseptics differ from disinfectants ? Give one example of each.
Antiseptics and disinfectants are effective against micro-organisms. However, antiseptics are applied to the living tissues such as wounds, cuts, ulcers, and diseased skin surfaces, while disinfectants are applied to inanimate objects such as floors, drainage system, instruments, etc. Disinfectants are harmful to the living tissues.
Iodine is an example of a strong antiseptic. Tincture of iodine (2 - 3 percent of solution of iodine in alcohol - water mixture) is applied to wounds. 1 percent solution of phenol is used as a disinfectant.
Why do soaps not work in hard water?
Explain the following terms with suitable examples
(i) cationic detergents
(ii) anionic detergents and
(iii) non-ionic detergents.
What are food preservatives ?
Sleeping pills are recommended by doctors to the patients suffering from sleeplessness but it is not advisable to take its doses without consultation with the doctor, Why?
Why is use of aspartame limited to cold foods and drinks?
With reference to which classification has the statement, ranitidine is an antacid been given?
What are the main constituents of dettol?
Write the chemical equation for preparing sodium soap from glyceryl oleate and glyceryl palmitate. Structural formulae of these compounds are given below.
(i) (C15H31COO)3 C3H5 - Glyceryl palmitate
(ii)(C17H33COO)3 C3H5 - Glyceryl oleate
What are artificial sweetening agents? Give two examples.
Name a substance which can be used as an antiseptic as well as disinfectant.
For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.
Write the formulas for the following coordination compounds:
(i) Tetraamminediaquacobalt (III) chloride
(ii) Potassium tetracyanonickelate(II)
(iii) Tris(ethane-1,2-diamine) chromium(III) chloride
(iv) Amminebromidochloridonitrito-N-platinate(II)
(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate
(vi) Iron(III) hexacyanoferrate(II)
(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N
(ii) Write IUPAC names of all the isomers.
(iii) What type of isomerism is exhibited by different pairs of amines?
Why are solids rigid?
Write any two characteristics of Chemisorption.
Write the structures of the following compounds.
(i) α-Methoxypropionaldehyde
(ii) 3-Hydroxybutanal
(iii) 2-Hydroxycyclopentane carbaldehyde
(iv) 4-Oxopentanal
(v) Di-sec-butyl ketone
(vi) 4-Fluoroacetophenone
Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?
Why are pentahalides more covalent than trihalides?
Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?
Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.
How do you explain the absence of aldehyde group in the pentaacetate of D-glucose?
What is meant by stability of a coordination compound in solution? State the factors which govern stability of complexes.
Which one of the following does not exist?
(i) XeOF4
(ii) NeF2
(iii) XeF2
(iv) XeF6
How are vitamins classified? Name the vitamin responsible for thecoagulation of blood.
What are lyophilic and lyophobic sols? Give one example of each type. Why are hydrophobic sols easily coagulated?
Calculate the potential of hydrogen electrode in contact with a solution whose pH is 10.
Why is Ka2 << Ka1 for H2SO4 in water?
Write down the number of 3d electrons in each of the following ions:
Ti2+, V2+, Cr3+, Mn2+, Fe2+, Fe3+, CO2+, Ni2+ and Cu2+.
Indicate how would you expect the five 3d orbitals to be occupied for these hydrated ions (octahedral).
Describe a method for the identification of primary, secondary and tertiary amines. Also write chemical equations of the reactions involved.
Why does nitrogen show catenation properties less than phosphorus?