Classify the following as primary, secondary and tertiary alcohols:
(i)
(ii) CH2C = CH - CH2OH
(iii) CH3 - CH2 - CH2 - OH
(iv)
(v)
(vi)
Primary alcohol → (i), (ii), (iii)
Secondary alcohol → (iv), (v)
Tertiary alcohol → (vi)
Explain the following with an example.
(i) Kolbe's reaction.
(ii) Reimer-Tiemann reaction.
(iii) Williamson ether synthesis.
(iv) Unsymmetrical ether.
How are the following conversions carried out?
(i) Propene → Propan-2-ol
(ii) Benzyl chloride → Benzyl alcohol
(iii) Ethyl magnesium chloride → Propan-1-ol.
(iv) Methyl magnesium bromide → 2-Methylpropan-2-ol.
Write the mechanism of acid-catalysed dehydration of ethanol to yield ethene.
Give the equations of reactions for the preparation of phenol from cumene.
Write equations of the following reactions:
(i) Friedel-Crafts reaction-alkylation of anisole.
(ii) Nitration of anisole.
(iii) Bromination of anisole in ethanoic acid medium.
(iv) Friedel-Craft's acetylation of anisole.
Explain why is ortho nitrophenol more acidic than ortho methoxyphenol?
Give two reactions that show the acidic nature of phenol. Compare acidity of phenol with that of ethanol.
Show how are the following alcohols prepared by the reaction of a suitable
Grignard reagent on methanal?
(i)
(ii)
Write the reactions of Williamson synthesis of 2-ethoxy-3-methylpentane starting from ethanol and 3-methylpentan-2-ol.
What is meant by hydroboration-oxidation reaction? Illustrate it with an example.
For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.
Write the formulas for the following coordination compounds:
(i) Tetraamminediaquacobalt (III) chloride
(ii) Potassium tetracyanonickelate(II)
(iii) Tris(ethane-1,2-diamine) chromium(III) chloride
(iv) Amminebromidochloridonitrito-N-platinate(II)
(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate
(vi) Iron(III) hexacyanoferrate(II)
(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N
(ii) Write IUPAC names of all the isomers.
(iii) What type of isomerism is exhibited by different pairs of amines?
Why are solids rigid?
Write any two characteristics of Chemisorption.
Write the structures of the following compounds.
(i) α-Methoxypropionaldehyde
(ii) 3-Hydroxybutanal
(iii) 2-Hydroxycyclopentane carbaldehyde
(iv) 4-Oxopentanal
(v) Di-sec-butyl ketone
(vi) 4-Fluoroacetophenone
Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?
Why are pentahalides more covalent than trihalides?
Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?
Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.
Calculate
(a) molality
(b) molarity and
(c) mole
fraction of KI if the density of 20% (mass/mass) aqueous KI is 1.202 g mL-1.
An aqueous solution of 2% non-volatile solute exerts a pressure of 1.004 bar at the normal boiling point of the solvent. What is the molar mass of the solute?
During nuclear explosion, one of the products is 90Sr with half-life of 28.1 years. If 1μg of 90Sr was absorbed in the bones of a newly born baby instead of calcium, how much of it will remain after 10 years and 60 years if it is not lost metabolically.
If the radius of the octachedral void is r and radius of the atoms in close packing is R, derive relation between r and R.
An element with molar mass 2.7 x 10-2kg mol-1 forms a cubic unit cell with edge length 405 pm. If its density is 2.7 x 103 kg m-3, what is the nature of the cubic unit cell?
How much electricity in terms of Faraday is required to produce
(i) 20.0 g of Ca from molten CaCl2.
(ii) 40.0 g of Al from molten Al2O3.
Why is ICl more reactive than I2?
How many lattice points are there in one unit cell of each of the following lattice?
(i) Face-centred cubic
(ii) Face-centred tetragonal
(iii) Body-centred
The reaction between A and B is first order with respect to A and zero order with respect to B. Fill in the blanks in the following table:
Experiment |
A/ mol L - 1 |
B/ mol L - 1 |
Initial rate/mol L - 1 min - 1 |
I | 0.1 | 0.1 |
2.0 × 10 - 2 |
II | -- | 0.2 |
4.0 × 10 - 2 |
III | 0.4 | 0.4 | -- |
IV | -- | 0.2 |
2.0 × 10 - 2 |
Explain why Cu+ ion is not stable in aqueous solutions?
Very nice app for chemistry