An electric bulb is rated 220 V and 100 W. When it is operated on 110 V, the power consumed will be –
(a) 100 W (b) 75 W (c) 50 W (d) 25 W
(d) Energy consumed by an appliance is given by the expression,
Where,
Power rating, P = 100 W
Voltage, V = 220 V
The resistance of the bulb remains constant if the supply voltage is reduced to 110 V. If the bulb is operated on 110 V, then the energy consumed by it is given by the expression for power as
Therefore, the power consumed will be 25 W.
When a 12 V battery is connected across an unknown resistor, there is a current of 2.5 mA in the circuit. Find the value of the resistance of the resistor.
A hot plate of an electric oven connected to a 220 V line has two resistance coils A and B, each of 24 Ω resistance, which may be used separately, in series, or in parallel. What are the currents in the three cases?
Calculate the number of electrons constituting one coulomb of charge.
Explain the following.
(a) Why is the tungsten used almost exclusively for filament of electric lamps?
(b) Why are the conductors of electric heating devices, such as bread-toasters and electric irons, made of an alloy rather than a pure metal?
(c) Why is the series arrangement not used for domestic circuits?
(d) How does the resistance of a wire vary with its area of cross-section?
(e) Why are copper and aluminium wires usually employed for electricity transmission?
Several electric bulbs designed to be used on a 220 V electric supply line, are rated 10 W. How many lamps can be connected in parallel with each other across the two wires of 220 V line if the maximum allowable current is 5 A?
An electric lamp of 100 Ω, a toaster of resistance 50 Ω, and a water filter of resistance 500 Ω are connected in parallel to a 220 V source. What is the resistance of an electric iron connected to the same source that takes as much current as all three appliances, and what is the current through it?
Let the resistance of an electrical component remains constant while the potential difference across the two ends of the component decreases to half of its former value. What change will occur in the current through it?
How much energy is given to each coulomb of charge passing through a 6 V battery?
Why are coils of electric toasters and electric irons made of an alloy rather than a pure metal?
Draw a schematic diagram of a circuit consisting of a battery of three cells of 2 V each, a 5 Ω resistor, an 8 Ω resistor, and a 12 Ω resistor, and a plug key, all connected in series.
Did Döbereiner’s triads also exist in the columns of Newlands’ Octaves? Compare and find out.
What is a good source of energy?
Why is diffusion insufficient to meet the oxygen requirements of multi-cellular organisms like humans?
What are trophic levels? Give an example of a food chain and state the different trophic levels in it.
What changes can you make in your habits to become more environment-friendly?
What is the difference between a reflex action and walking?
What is the importance of DNA copying in reproduction?
If a trait A exists in 10% of a population of an asexually reproducing species and a trait B exists in 60% of the same population, which trait is likely to have arisen earlier?
Why should a magnesium ribbon be cleared before burning in air?
Define the principal focus of a concave mirror.
Why are traits acquired during the life-time of an individual not inherited?
What is the role of saliva in the digestion of food?
Which of the following is not a part of the female reproductive system in human beings?
(a) Ovary
(b) Uterus
(c) Vas deferens
(d) Fallopian tube
How has the traditional use of wind and water energy been modified for our convenience?
What are the changes seen in girls at the time of puberty?
Define 1 dioptre of power of a lens.
What would be the advantages of exploiting resources with short-term aims?
By considering their position in the Periodic Table, which one of the following elements would you expect to have maximum metallic characteristic?
Ga Ge As Se Be
You are given a hammer, a battery, a bulb, wires and a switch.
(a) How could you use them to distinguish between samples of metals and non-metals?
(b) Assess the usefulness of these tests in distinguishing between metals and non-metals.
What are the environmental consequences of the increasing demand for energy? What steps would you suggest to reduce energy consumption?