Use the data in Table 12.2 to answer the following –
(a) Which among iron and mercury is a better conductor?
(b) Which material is the best conductor?
(a) The Resistivity of mercury is more than that of iron. So mercury offer more resistance than that iron whereas iron have lower resistivity and offer less resistance therefore iron is a better conductor than mercury
Resistivity of iron = 10.0 x 10-8
Resistivity of mercury = 94.0 × 10−8
(b) Silver is the best conductor of electricity because of lowest resistivity and offers lower resistance as shown according to the above table.
When a 12 V battery is connected across an unknown resistor, there is a current of 2.5 mA in the circuit. Find the value of the resistance of the resistor.
A hot plate of an electric oven connected to a 220 V line has two resistance coils A and B, each of 24 Ω resistance, which may be used separately, in series, or in parallel. What are the currents in the three cases?
Calculate the number of electrons constituting one coulomb of charge.
Explain the following.
(a) Why is the tungsten used almost exclusively for filament of electric lamps?
(b) Why are the conductors of electric heating devices, such as bread-toasters and electric irons, made of an alloy rather than a pure metal?
(c) Why is the series arrangement not used for domestic circuits?
(d) How does the resistance of a wire vary with its area of cross-section?
(e) Why are copper and aluminium wires usually employed for electricity transmission?
Several electric bulbs designed to be used on a 220 V electric supply line, are rated 10 W. How many lamps can be connected in parallel with each other across the two wires of 220 V line if the maximum allowable current is 5 A?
An electric lamp of 100 Ω, a toaster of resistance 50 Ω, and a water filter of resistance 500 Ω are connected in parallel to a 220 V source. What is the resistance of an electric iron connected to the same source that takes as much current as all three appliances, and what is the current through it?
Let the resistance of an electrical component remains constant while the potential difference across the two ends of the component decreases to half of its former value. What change will occur in the current through it?
Why are coils of electric toasters and electric irons made of an alloy rather than a pure metal?
How much energy is given to each coulomb of charge passing through a 6 V battery?
A copper wire has diameter 0.5 mm and resistivity of 1.6 × 10–8 Ω m. What will be the length of this wire to make its resistance 10 Ω? How much does the resistance change if the diameter is doubled?
Did Döbereiner’s triads also exist in the columns of Newlands’ Octaves? Compare and find out.
What is a good source of energy?
Why is diffusion insufficient to meet the oxygen requirements of multi-cellular organisms like humans?
What are trophic levels? Give an example of a food chain and state the different trophic levels in it.
What changes can you make in your habits to become more environment-friendly?
What is the difference between a reflex action and walking?
What is the importance of DNA copying in reproduction?
If a trait A exists in 10% of a population of an asexually reproducing species and a trait B exists in 60% of the same population, which trait is likely to have arisen earlier?
Why should a magnesium ribbon be cleared before burning in air?
Define the principal focus of a concave mirror.
What change will you observe if you test soap with litmus paper (red and blue)?
By considering their position in the Periodic Table, which one of the following elements would you expect to have maximum metallic characteristic?
Ga Ge As Se Be
At the time of short circuit, the current in the circuit
(a) reduces substantially.
(b) does not change.
(c) increases heavily.
(d) vary continuously.
How does the electronic configuration of an atom relate to its position in the Modern Periodic Table?
How can ethanol and ethanoic acid be differentiated on the basis of their physical and chemical properties?
Draw a labelled diagram of the longitudinal section of a flower.
Give any two ways in which non-biodegradable substances would affect the environment.
Why is vegetative propagation practised for growing some types of plants?
What are the advantages of sexual reproduction over asexual reproduction?
Give a test that can be used to differentiate between saturated and unsaturated hydrocarbons.