Class 10 Science - Chapter Electricity NCERT Solutions | On what factors does the resistance of a

When a 12 V battery is connected across an unknown resistor, there is a current of 2.5 mA in the circuit. Find the value of the resistance of the resistor.

A hot plate of an electric oven connected to a 220 V line has two resistance coils A and B, each of 24 Ω resistance, which may be used separately, in series, or in parallel. What are the currents in the three cases?

Calculate the number of electrons constituting one coulomb of charge.

Explain the following.

(a) Why is the tungsten used almost exclusively for filament of electric lamps?
(b) Why are the conductors of electric heating devices, such as bread-toasters and electric irons, made of an alloy rather than a pure metal?
(c) Why is the series arrangement not used for domestic circuits?
(d) How does the resistance of a wire vary with its area of cross-section?
(e) Why are copper and aluminium wires usually employed for electricity transmission?

Several electric bulbs designed to be used on a 220 V electric supply line, are rated 10 W. How many lamps can be connected in parallel with each other across the two wires of 220 V line if the maximum allowable current is 5 A?

An electric lamp of 100 Ω, a toaster of resistance 50 Ω, and a water filter of resistance 500 Ω are connected in parallel to a 220 V source. What is the resistance of an electric iron connected to the same source that takes as much current as all three appliances, and what is the current through it?

Let the resistance of an electrical component remains constant while the potential difference across the two ends of the component decreases to half of its former value. What change will occur in the current through it?

Why are coils of electric toasters and electric irons made of an alloy rather than a pure metal?

How much energy is given to each coulomb of charge passing through a 6 V battery?

Draw a schematic diagram of a circuit consisting of a battery of three cells of 2 V each, a 5 Ω resistor, an 8 Ω resistor, and a 12 Ω resistor, and a plug key, all connected in series.

Did Döbereiner’s triads also exist in the columns of Newlands’ Octaves? Compare and find out.

What is a good source of energy?

Why is diffusion insufficient to meet the oxygen requirements of multi-cellular organisms like humans?

What are trophic levels? Give an example of a food chain and state the different trophic levels in it.

What changes can you make in your habits to become more environment-friendly?

What is the difference between a reflex action and walking?

What is the importance of DNA copying in reproduction?

If a trait A exists in 10% of a population of an asexually reproducing species and a trait B exists in 60% of the same population, which trait is likely to have arisen earlier?

Why should a magnesium ribbon be cleared before burning in air?

Define the principal focus of a concave mirror.

What were the limitations of Newlands’ Law of Octaves?

The far point of a myopic person is 80 cm in front of the eye. What is the nature and power of the lens required to correct the problem?

Why is variation beneficial to the species but not necessarily for the individual?

Why is damage to the ozone layer a cause for concern? What steps are being taken to limit this damage?

What are the different ways in which glucose is oxidised to provide energy in various organisms?

We saw in this chapter that there are four main stakeholders when it comes to forests and wildlife. Which among these should have the authority to decide the management of forest produce? Why do you think so?

How does binary fission differ from multiple fission?

Which of the following lenses would you prefer to use while reading small letters found in a dictionary?

(a) A convex lens of focal length 50 cm.
(b) A concave lens of focal length 50 cm.
(c) A convex lens of focal length 5 cm.
(d) A concave lens of focal length 5 cm.

How is oxygen and carbon dioxide transported in human beings?

Use Mendeléev’s Periodic Table to predict the formulae for the oxides of the following elements:

    K,     C,      AI,      Si,      Ba.