Prepare a list of objects around you that are electroplated.
In case of a fire, before the firemen use the water hoses, they shut off the main electrical supply for the area. Explain why they do this.
The process that you saw in Activity 14.7 is used for purification of copper. A thin plate of pure copper and a thick rod of impure copper are used as electrodes. Copper from impure rod is sought to be transfered to the thin copper plate. Which electrode should be attached to the positive terminal of battery and why?
Does pure water conduct electricity? If not, what can we do to make it conducting?
Name three liquids, which when tested in the manner shown in Fig.14.9, may cause the magnetic needle to deflect.
The bulb does not glow in the setup shown in Fig.14.10. List the possible reasons. Explain your answer.
Fill in the blanks
(a) Most liquids that conduct electricity are solutions of , ______________ and ______________.
(b) The passage of an electric current through a solution causes ______________ effects.
(c) If you pass current through copper sulphate solution, copper gets deposited on the plate connected to the terminal of the battery.
(d) The process of depositing a layer ofany desired metal on another material by means of electricity is called .
Paheli had heard that rainwater is as good as distilled water. So she collected some rainwater in a clean glass tumbler and tested it using a tester. To her surprise she found that the compass needle showed deflection. What could be the reasons?
Is it safe for the electrician to carry out electrical repairs outdoors during heavy downpour? Explain.
A tester is used to check the conduction of electricity through two liquids, labeled A and B. It is found that the bulb of the tester glows brightly for liquid A while it glows very dimly for liquid B. You would conclude that
(i) liquid A is a better conductor than liquid B.
(ii) liquid B is a better conductor than liquid A.
(iii) both liquids are equally conducting.
(iv) conducting properties of liquid cannot be compared in this manner.
When the free ends of a tester are dipped into a solution, the magnetic needle shows deflection. Can you explain the reason?
Which of the following can be beaten into thin sheets?
(a) Zinc (b) Phosphorus (c) Sulphur (d) Oxygen
Give two examples each of situations in which you push or pull to change the state of motion of objects.
Fill in the blanks:
(a) Friction opposes the _____________ between the surfaces in contact with each other.
(b) Friction depends on the _____________ of surfaces. (c) Friction produces __________.
(d) Sprinkling of powder on the carrom board ________ friction.
(e) Sliding friction is ___________ than the static friction.
List conditions under which combustion can take place.
Indicate whether the following statements are True (T) or False (F).
(a) Unicellular organisms have one-celled body. (T/F)
(b) Muscle cells are branched. (T/F)
(c) The basic living unit of an organism is an organ. (T/F)
(d) Amoeba has irregular shape. (T/F)
Which of the following cannot be charged easily by friction?
(a) A plastic scale
(b) A copper rod
(c) An inflated balloon
(d) A woollen cloth.
Fill in the blanks:
(a) A place where animals are protected in their natural habitat is called .
(b) Species found only in a particular area is known as .
(c) Migratory birds fly to far away places because of changes.
Suppose you are in a dark room. Can you see objects in the room? Can you see objects outside the room. Explain.
What are the different ways in which water gets contaminated ?
Explain the importance of reproduction in organisms.
Explain why the sliding friction is less than the static friction.
Fill in the blanks:
(a) A place where animals are protected in their natural habitat is called .
(b) Species found only in a particular area is known as .
(c) Migratory birds fly to far away places because of changes.
Fill in the blanks:
(a) Friction opposes the _____________ between the surfaces in contact with each other.
(b) Friction depends on the _____________ of surfaces. (c) Friction produces __________.
(d) Sprinkling of powder on the carrom board ________ friction.
(e) Sliding friction is ___________ than the static friction.
Suppose you are in a dark room. Can you see objects in the room? Can you see objects outside the room. Explain.
Explain the process of formation of petroleum.
Describe how coal is formed from dead vegetation. What is this process called?
Indicate whether the following statements are True (T) or False (F).
(a) Unicellular organisms have one-celled body. (T/F)
(b) Muscle cells are branched. (T/F)
(c) The basic living unit of an organism is an organ. (T/F)
(d) Amoeba has irregular shape. (T/F)
Select the correct word from the following list and fill in the blanks.
float, water, crop, nutrients, preparation
(a) The same kind of plants grown and cultivated on a large scale at a place is called _____________.
(b) The first step before growing crops is _____________ of the soil.
(c) Damaged seeds would _____________ on top of water.
(d) For growing a crop, sufficient sunlight and _____________ and _____________ from the soil are essential.
A rocket has been fired upwards to launch a satellite in its orbit. Name the two forces acting on the rocket immediately after leaving the launching pad.
In the following situations identify the agent exerting the force and the object on which it acts. State the effect of the force in each case.
(a) Squeezing a piece of lemon between the fingers to extract its juice.
(b) Taking out paste from a toothpaste tube.
(c) A load suspended from a spring while its other end is on a hook fixed to a wall.
(d) An athlete making a high jump to clear the bar at a certain height.